Preparing To Work Inside The Computer; Recommended Tools - Dell Inspiron 4150 Owner's Manual
Hide thumbs
Also See for Inspiron 4150 :
- User manual (163 pages) ,
- Owner's manual (144 pages) ,
- Setup manual (2 pages)
Table of Contents
Advertisement
Back to Contents Page
Before You Remove or Replace Parts
Dell™ Inspiron™ 4150
Preparing to Work Inside the Computer
Recommended Tools
Screw Identification
Preparing to Work Inside the Computer
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow applicable safety instructions in the Owner's Manual that came with the computer.
NOTICE:
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
1. Ensure that the work surface is clean to prevent scratching the computer cover.
2. Save any work in progress and exit all open programs.
3. Turn off the computer and all attached devices.
HINT:
Ensure that the computer is turned off and not in suspend mode or hibernate mode. If you cannot shut down the computer using the computer
operating system, press and hold the power button for 4 seconds.
4. Ensure that the computer is undocked.
5. Disconnect the computer from the electrical outlet.
6. To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.
7. Disconnect all other external cables from the computer.
8. Remove any installed PC Cards or plastic blanks from the PC Card slot.
9. Close the display and turn the computer upside down on a flat work surface.
NOTICE:
To avoid damaging the system board, you must remove the main battery and secondary battery (if present) before you service the computer.
10. Remove the primary battery from the battery bay and the secondary battery from the module bay, if a secondary battery is in use.
11. Remove any device installed in the module bay.
12. To dissipate any static electricity while you work, use a wrist grounding strap or periodically touch an unpainted metal surface.
13. Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by it edges or by its metal mounting bracket.
Hold a component such as a microprocessor by its edges, not by its pins.
Recommended Tools
The procedures in this manual require the following tools:
#1 magnetized Phillips screwdriver
l
¼-inch flat-blade screwdriver
l
Small plastic scribe
l
Microprocessor extractor
l
Flash BIOS update program CD
l
Advertisement
Table of Contents
