Hitachi GD-2000 Installation Manual page 3

GD-2000 Manual 6/18/98 5:21 PM
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC RULES. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Module dürfen nur an eine Sicherheits-Kleinspannungs-Versorgung(SELV-
Kreise) nach EN609501/VDE 0805 angeschlossen werden. Die Trennung von
Netzspannung muß durch einen Sicherheitstransformator geschehen.
Page 3
1) Re-orientate or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
For Germany / Für Deutschland
GD 2000 DVD ROM M
For USA
l P