Appendix; General Troubleshooting - Chauvet MiN Laser FX 2.0 User Manual

5. A
PPENDIX

General Troubleshooting

If you still have a problem after trying the above solutions, please contact CHAUVET®
Technical Support.
MinLasers 2.0 User Manual
S P
YMPTOM OSSIBLE
 Excessive circuit load
Breaker/Fuse
 Short circuit along the power
keeps blowing
wires
 No power
Device does not
 Loose power cord
power up
 Wrong DMX addressing
 Damaged DMX cables
Product is not
 Wrong polarity settings on the
responding to
controller
DMX
 Loose DMX cables
 Faulty DMX interface
 Faulty Main PCB
 Non DMX cables
 Bouncing signals
 Long cable / Low level signal
Loss of signal
 Too many products
 Interference from AC wires
C ( )
AUSE S
 Check total load placed on the
electrical circuit.
 Check for a short in the electrical
wiring (internal and/or external).
 Check for power on Mains.
 Check power cord
 Check Control Panel and unit
addressing
 Check DMX cables
 Check polarity switch settings on
the controller
 Check cable connections
 Replace DMX input
 Replace Main PCB
 Use only DMX compatible cables
 Install terminator as suggested.
 Install amplifier right after product
with strong signal.
 Install an optically coupled DMX
splitter after unit #32.
 Keep DMX cables separated from
power cables or black lights.
13
P A ( )
OSSIBLE CTION S
August 2011