Linux - Equinox Systems ESP-2 Product Installation Manual

Linux

The following sections contain procedures for installing the ESP driver on a Linux system.
Creating Linux ESP Installation Diskettes on Linux
1. Mount the CD-ROM volume using the following command:
mount -t iso9660<device> <mount _point>
For example, the following command mounts the fi rst CD-ROM in a typical
environment:
mount -t iso9660/dev/cdrom /mnt/cdrom
2. Run the following commands:
cd /mnt/cdrom
./makeunix.sh
3. Follow the on-screen instructions to build an installation diskette for Linux ESP.
4. Once the Linux installation diskette is created, refer to the following fi le for detailed
instructions: /drivers/esp/linux/readme.txt
Creating Linux ESP Installation Diskettes on DOS
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
2. Set your default drive to the CD-ROM drive letter.
3. Run the command
system for which diskettes are needed.
4. Once the Linux installation diskette is created, refer to the following fi le for detailed
instructions: /drivers/esp/linux/readme.txt
Creating Linux ESP Installation Diskettes on Windows
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
• If you have autoplay enabled, the Equinox SuperSerial Software Installation screen
will appear.
• If you do not have autoplay enabled, set your default drive to D: and run the com-
mand
D:\SETUP,
2. Click UNIX on the Main Window.
3. Select the UNIX operating system for which you need drivers. Follow the on-screen
instructions for creating an installation diskette.
4. Once the Linux installation diskette is created, refer to the following fi le for detailed
instructions: /drivers/esp/linux/readme.txt
14
Equinox ESP-2 MI Serial Hub Product Installation Guide
[or other mount point]
and select the appropriate Equinox product and operating
MAKEUNIX
where D: is your CD-ROM drive letter.