Sharp R-4A52 Service Manual page 26

R-4A52
R-4E52
OVEN LAMP SOCKET REMOVAL
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
CARRY OUT 3D CHECKS
Lift up the tab holding the oven lamp socket.
Remove the oven lamp socket.
Pull the wire leads from the oven lamp socket by
pushing the terminal hole of the oven lamp socket
with the flat type small screw driver.
Now, the oven lamp socket is free.
Oven lamp socket
Flat type
screw dri
Figure C-3. Oven lamp socket
UPPER LATCH SWITCH, LOWER LATCH SWITCH,
STOP SWITCH AND MONITOR SWITCH REMOVAL
CARRY OUT 3D CHECKS.
Remove the air duct from the oven cavity.
Disconnect the main wire harness and switch har-
ness from the control panel.
Disconnect the leads from all switches.
Remove the two (2) screws holding the latch hook
to the oven cavity.
Remove the latch hook.
Push the retaining tab slightly and remove the
switch.
Monitor
I /
Upper latch switch
switch
Lower latch switch
Figure C-4. Switches
25