Controls And Functions - American DJ ScanTron User Instructions

ScanTron™
REAR
1
2
3
4
FRONT
10
11
12
13
1
1. Thumb Screw - This thumb screw holds the lamp socket assem-
bly cover (16) into place.
2. Audio Sensitivity Knob - Audio Sensitivity Knob - This adjust audio sensitivity of the
INTERNAL MICROPHONE (3). Turning the sensitivity knob in the
clockwise direction will increase the sensitivity to sound. Turning the
knob in the counter clockwise direction will decrease the fi xture's sen-
sitivity to sound.
3. Dip Switches - Dip Switches - These switches serve two functions. In DMX mode
each switch corresponds to a specifi c value based on binary code.
See page 7 for a detailed explanation of DMX binary code. When the
unit is operating in master/slave mode the pan and tilt movements may
American DJ - www.americandj.com - ScanTron™ Instruction Manual Page 5
© ®

Controls and Functions

5
6
7
8
9
14
ScanTron™
be inverted by moving dip switch 10 to the "on" position. All other dip
switches have no function in master/slave mode.
4. Microphone - Microphone - This microphone receives external low frequencies
to trigger the unit in Sound-Active and Master/Slave mode.
5. IRC/1 Controller Jack - IRC/1 Controller Jack - This jack is for use with the optional IRC/1
controller only. Do not attempt to connect an audio signal to this jack,
this will damage the PC board and void your manufactures warranty!
6. XLR Output Jack - XLR Output Jack - This jack is used to transmit the incoming
DMX signal to another DMX fi xture, or transmit a Master/Slave signal
to the nest ScanTron™ in the chain. For best results in DMX or Master/
Slave mode terminate this jack if it is the last unit in the chain. See
"Terminator" on page 7.
7. XLR Input Jack - XLR Input Jack - This jack is used to accept an incoming DMX
signal or Master/Slave signal.
8. Fuse Holder - This housing stores the 5 amp (3 amp 220v) protec-
tive fuse.
9. Power Cord - Power Cord - Connect only to a matching power outlet. Never
usethis fi xture is the ground prong has been removed or broken off.
10. Mirror - This is a highly refl ective surface mirror specifi cally
designed to optimize and enhance beam output. Never use glass
cleaner that contain ammonia to clean the surface of the mirror (such
as Windex).
11. Lens - Lens - This is a fully focusing high quality lens. Focus the lens by
manually turning the lens in a clockwise or counter-clockwise direc-
tion.
12. Mirror Interface - This connection is used to create an interface
between the mirror head and the unit body. Disconnect this interface
when the unit is going to be used as a color changer with the mirror
piece removed.
13. Lamp Socket Assembly - Lamp Socket Assembly - This assembly holds a LL-ELC (24v/
250w) lamp.
14. Lamp Socket Assembly Plate - This plate is used to protect and
accesses the lamp socket assembly.
American DJ - www.americandj.com - ScanTron™ Instruction Manual Page 6
© ®
Controls and Functions