Table of Contents
Advertisement
Chapter 6: Setting Advanced Properties
Opening Advanced Properties
62
In most cases, the default property values are appropriate although you
can change any of the available options to meet the requirements of your
system. You must have Administrator privileges to modify the driver
software. After the driver software has been installed, you can use the
following procedures to verify or change the adapter properties:
"Flow Control" on page 63
"Interrupt Moderation" on page 65
"IPSec Offload" on page 65
"Large Send Offload Property" on page 67
"Network Address" on page 68
"Priority & VLAN" on page 69
"Receive Side Scaling" on page 70
"Speed & Duplex Mode" on page 70
"Checksum Offload" on page 71
"VLAN ID" on page 72
"Wake Up Capabilities" on page 73
"WOL Speed" on page 74
Note
After you upgrade the driver software, the Advanced Properties may
change.
Note
The procedures in the sections listed above may differ slightly if the
"Classic Start Menu" is set on your computer.
Advertisement
Table of Contents
