Installing The Module - Allied Telesis AT-2812FX Installation And User Manual

Expresscard fast ethernet fiber (sc) module

Hide thumbs Also See for AT-2812FX:

Table of Contents

Installing the Module

AT-2812FX ExpressCard Fast Ethernet Fiber (SC) Module Installation and User's Guide

The following instructions describe how to install the AT-2812FX module in

a laptop equipped with a PCI ExpressCard interface slot. This procedure

applies to laptops with either 34 mm or 54 mm interface slots. For laptop

computers, the 54 mm interface is the more common interface. Therefore,

the installation illustrations in this manual use the 54 mm interface.

For additional details about performing these tasks on your particular PC,

refer to the manual that was supplied with your laptop.

Note

Allied Telesis recommends that you turn off your PC before installing

the AT-2812FX module.

Note

To perform this procedure, you need to supply a pen.

To install an AT-2812FX module, perform the following procedure:

1. Review the "Pre-Installation Checklist" on page 24 and "Reviewing

Safety Precautions" on page 22.

Before installing the module, ensure the laptop power is OFF and

unplugged from the power outlet.

2. Select the 34 mm or 54 mm ExpressCard slot.

See Figure 3 on page 26 for an example of the 54 mm ExpressCard

slot.

Note

If you do not know how to identify a PCI ExpressCard slot, refer to

your laptop documentation.

Table of Contents