Panasonic FV-08VKML1 Installation Instructions Manual page 9

INSTALLATION INSTALLATION
2. Install the suspension bracket and the flange of fan body
to joists by using long screws (ST4.2X20) ( If spacing A
between joists is 12 inches, install the flange of fan body
according to Fig.2-1, others according to Fig.2-2 to install
the product)
3. Install the suspension bracket to joists by using long
screws (ST4.2X20) and secure it to the fan body by
II
using screw (ST4.2X12) (Fig.3)
4. Remove junction box cover and secure conduit or
stress relief to junction box knock-out hole. (Fig.4)
5. Refer to wiring diagram of page 5.
Follow all the local electrical safety codes. As well as
the National Electrical Code (NEC).
Using UL approved wire nuts, connect house power
wires to ventilating fan wires:
black to black; white to white; green to green;
Connect the two red wires to the switch for the speed
control. Replace the junction box cover. (Fig.4)
CAUTION:
Mount junction box cover carefully so that lead
wires are not pinched.
6. Install a circular duct and secure it with duct tape or
clamps.
I I JOIST MOUNTING- JOIST MOUNTING-
( (
I I
) CONTINUED ) CONTINUED
Fan body
2 Long screws
(ST4.2X20)
Fan body
4 Long screws (ST4.2X20)
2 Long screws
(ST4.2X20)
Conduit
Junction box cover
Junction box
Conduit
Green wires
Lead wires Wire nut
9
Joist
Fig.2-1
Fig.2-2
II
Screw (ST4.2X12)
Circular duct
Joist
Duct tape
Conduit
Junction box
Green wires
Red wires
Lead wires
Wire nut
Joist
Joist
Fig.3
Fig.4