Inverter Status; Display Information - AEG Protect PV 2000 Operating Instructions Manual

6. iNvERTER STaTuS

operatinG conditions
normal workinG status
Power off
Standby
Initialization & waiting
Check grid
Feeding grid, MPPT
FLASH
Today energy
monitorinG parameters
Instantaneous
Output power
Accumulated energy
information
Grid voltage
Grid frequency
Protect PV is designed to be user-friendly; therefore, the status of the
Inverter can be easily understood by reading the information shown
on the front panel display. All possible messages are shown in the
following table.

display information

messaGe
no display
STAnDBy
READy
CHECKInGxxxs
GRID COnnECTED
FLASH
Etoday=xxx.xxkWh
Pac=xxx.xW
Etot=xxxxxxkWh
Vac=xxx.xV
Fac=xx.xHz
description
PV inverter is totally
shutdown, VPV <=70V
90V< Input voltage < =100V
Input voltage range 100~150V
during start-up. After PV
voltage is higher than 100V,
inverter is waiting for feeding
to grid
When PV voltage> 150V,
inverter is checking feeding
conditions
Inverter is feeding power. After 10
seconds of this display, LED will show
wattage.
FLASH-firmware
Total energy to has been fed
to grid since today
The real time output power in xxxx W
Total energy to has been fed
to grid since inverter was
installed
Grid voltage in xxx.x VAC
Grid frequency in xx.x Hz
21