Table of Contents
Advertisement
Adjust Speaker Volume
To adjust the volume in your earpiece, press the increase or decrease volume button
for 1 second, then release. Repeat until volume is at desired level. You will hear a sin-
gle beep each time you press the button.
Mute The Microphone On The Headset
To mute the microphone, press and hold down the Increase Volume button for 4 sec-
onds. You will hear a beep and the microphone will mute. A beep will be heard peri-
odically indicating that the microphone is in Mute Mode. This will not be heard on the
other end of the call.
Un-Mute The Microphone On The Headset
To un-mute the microphone, press and hold down the Increase Volume button for 4
seconds. You will hear a beep and the microphone will un-mute.
HEADSET ADJUSTMENTS / MICROPHONE POSITIONING
Microphone positioning is important to ensure proper microphone performance.
Headset Adjustment
1. Place the headset on your head with the ear cushion on your left or right ear.
2. Swivel microphone boom up and over, if necessary, to bring it to the chosen side.
3. Place T-bar on the side of your head above your ear.
4. Slide headband in or out for a secure fit.
Microphone Positioning
1. The microphone has a dot printed on it under the cushion. This mark must face
your mouth.
2. For quality voice input and effective background noise cancellation, position
16
microphone a finger's width away from your face just below your bottom lip. Because
the B1000-GTX professional grade microphone is sensitive, you may need to make
slight adjustments in positioning to achieve optimum sound quality.
USING THE B1000-GTX HEADSET WITH YOUR COMPUTER
Before use, make sure the headset is on (page 15). Refer to headset controls on page 6.
1. Put the headset on and position the microphone properly.
2. Put the headset in Talk Time mode* by pressing the multifunction button for 1 sec-
ond and then releasing it. You will hear a single beep. Base unit will indicate bright
green LED.
*If the yellow indicator light on the headset is flashing quickly, about once per second,
then the headset is already in Talk Time mode and you may proceed to step 3.
3. Activate the computer software program as usual.
4. To end the headset's communication with the computer, press the multifunction
button on the headset for 1 second, then release. Base unit green LED will change
from bright to dim.The headset is now in Standby Mode and the yellow indicator light
on the headset will be flashing slowly,every 4-5 seconds. Wait several seconds for the
indicator light to change speeds after you press the multifunction button.
Tip for users of speech recognition applications:
If you are using speech recognition software applications it is recommended
that a new user file be created and trained before dictating.
17
Advertisement
Table of Contents
