GB 22-06-2001 12:11 Pagina 32
CHAPTER 2 – USING THE CONTROLS AND SETTING THE MODES
2.1 SETTING THE CLOCK
•
When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the time of day, proceed as described below:
•
If you wish to change the hour on the dial once it has been set, press the "
ding to set the new time as described above.
•
It is possible to display the current time even after starting the mode set, by pressing the "
(the time is displayed for 2 seconds).
32
1
Press the
key (9).
(The hours flash on display)
2
Set the desired time by tur-
ning the TIME ADJUST knob
(8).
(The hours flash on display)
3
Press the
key (9) again.
(The minutes flash on display)
4
Set the desired minutes by tur-
ning the TIME ADJUST knob
(8)
(The minutes flash on display)
5
Press the
key (9) again.
(The display shows the time set)
" key (9) before procee-
" key (9)
32