Backlight; Set Time; Set Date; About - Omnia -6EX / EXi Installation And Operation Manual

Omnia-6EX has been locked. The I/O metering continues to function normally, and the currently running Preset
Name is replaced by the text "System is Locked". See the Security Config section below for details.
It is advisable to change the passwords once the Omnia-6EX is installed. Passwords are case sensitive and can
contain up to ten characters. See the Change Password section below for details.

Backlight

This setting determines the time it takes for the LCD screens to turn off after the last time the jog wheel has been
used. The selections are 5 min, 15 min or 1 hour. To preserve the life of the LCD backlight, there is no option
available for continuous operation.

Set Time

Sets the current time for the unit, which must be set before dayparts can be used. The time is set using the familiar
"turn and push" action of the jog-wheel.
Note: The time can be synchronized to ":00" seconds by pressing the jog wheel in synchronization with the seconds
indicator of an external clock. To maintain accurate dayparting, you should periodically reset the internal clock to
your external reference. The Real Time Clock IC used in the Omnia-6EX typically has an accuracy of better than +/-
0.5 minutes per month.
Note: An additional menu will prompt you to set the unit to Daylight Saving or Standard time.
Note: There is now an NTP time function available, which can synchronize the Omnia time to an external source
connected to its Ethernet jack. This time can be from a local GPS based device (for instance) or from a connection to
the Internet. See the NTP section below for more details.

Set Date

Sets the current date, which needs to be done before daypart scheduling can be used. The date is set using the
familiar "turn and push" action of the jog wheel.

About

Displays a window listing the system software versions that are currently loaded and running.

Change Password

Opens up a window so that the selected Security Level password can be changed. The factory default passwords
are:
Level 1 – user (all lower case)
Level 2 – advuser (all lower case)
Level 3 – engineer (all lower case)
To change a password, use the standard click and turn of the jog-wheel to select the character position you wish to
change and to select the new character for that position.
After entering a new password, highlight the checkmark and click the jog-wheel to save the password. If you wish
to cancel the operation, highlight the "X" and click the jog-wheel.
Caution: Passwords for each level must be unique. Do not assign the same password to multiple security levels!
You will lock yourself out of the unit!
Omnia-6ex Use and Operation Manual – V: 1.20
46