Cooktop Safety; Installation Requirements; Tools And Parts - KitchenAid 30" (76.2 cm) Cooktop Installation Instructions Manual

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
Flat-blade screwdriver
Phillips head screwdriver
Drill
Level
6" socket extension
Parts supplied
Vent grille
Pre-filter
2

COOKTOP SAFETY

Your safety and the safety of others are very important.

INSTALLATION REQUIREMENTS

Marker or pencil
Pliers
¼" drill bit
Jigsaw
Ratchet with "socket
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.

Tools and Parts

Parts needed
A UL listed or CSA approved strain relief for
knockout.
A UL listed or CSA approved conduit connector for
" (1.3 cm) trade-size metal-clad conduit
UL listed wire connectors
Metal ducting
Wall cap
6" (15.2 cm) Round Surface Wall Cap Damper
Order Part Number A406
5" (12.7 cm) Round Surface Wall Cap Damper
Order Part Number A405
3¼" x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper
Order Part Number A403
To order, see the "Assistance or Service" section of the Use
and Care Guide.
Vent clamps
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section.
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
" (2.2 cm)