Panasonic AG-RT650P Operating Instructions Manual page 8

Part and Their Functions
AC IN
r
q
Camera switching output connector
Camera switching output connector; connect it to
the sequential switcher.
w
Audio input/output connectors
Audio input/output connectors (phono jacks)
e
Video input/output connectors
Video input/output connectors (BNC); connect the
input connector to the video camera, etc. and the
output connector to the TV monitor, etc.
r
AC IN connector
Connect the supplied power cord to an AC outlet.
t
Alarm input connector
Alarm recording input connector; connect it to the
external sensor.
y
COMMON terminal
u
Alarm reset connector
Input connector for releasing alarm recording; a +4
to +14 V DC voltage is required.
i
REC IN connector
Input connector for recording.
q w e
CAMERA
SW OUT
IN IN
AUDIO
VIEDO
OUT
OUT
ALARM RESET IN TAPE END OUT
GND
WARNING/
ALARM IN REC OUT
COMMON REC IN
ty u i o !0 !1 !2 !3
o
Tape end output connector
When the cassette tape comes to its end during
recording, the alarm device installed externally is
activated.
!0
WARNING/REC output connector
When trouble has occurred in the unit, the alarm
device installed externally is activated.
Error warning or recording low signal selected on
the menu screen 3 is output.
!1
GND terminal
This terminal is connected to the signal ground
terminal of the connected unit in order to reduce
noise. It is not connected to ground for safety
purposes.
!2
MIC input jack
Input jack (mini-jack) for an external microphone.
This jack has precedence when signals are supplied
simultaneously to this jack and the audio input
connectors.
!3
REMOTE control connector
For connecting the AG-A11 remote controller which
is available as an optional accessory.
!4
Battery installation area
Install the battery in this area. See "Lithium Battery"
on page 2.
8
BATTERY
PUSH OPEN
MIC
REMOTE
!4