Lenovo ThinkStation 2551 Hardware Maintenance Manual page 73

POST Error code
1762
SATA device configuration change has
occurred
1820
More than one external fingerprint reader
is attached. Power off and remove all but
the reader that you set up within your main
operating system.
1962 No operating system found. Press any key
to repeat boot sequence.
0162 Setup data integrity check failure
0167 No processor microcode update found
0175 System Security - Security data corrupted
0176
System Security - The system has been
tampered with
0189 System Security - Can not read the
Security EEPROM
0197
System Security - Unauthorized security
data change detected
0190 System Security - Invalid security change
requested
0199
System Security - Security password retry
count exceeded
POST Error message Description/Action
This error message is displayed when a hard disk
drive or optical drive change has been made.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
If more than one external fingerprint reader is
connected to a computer, this error message will
be displayed to inform you to remove all of the
fingerprint keyboards except the one compatible
with the fingerprint application on your computer.
This error occurs only after the POST is completed.
Press any key to repeat boot sequence.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
This error message indicates that there is
no microcode update image for the current
microprocessor.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
This error message is displayed when the
computer is turned on with the cover open or
removed.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
This error message indicates that the Security
EEPROM may be broken or removed.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
.
Chapter 8 Symptom-to-FRU Index
67