Scan - Kenwood TK-7302 Instruction Manual

Scan monitors for signals on the transceiver channels. While scanning, the
transceiver checks for a signal on each channel and only stops if a matching
signal is present.
To start/stop scanning, press the key programmed as Scan On/Off.
• "Sc" appears on the display during Scan.
• When a signal is detected, Scan pauses at that channel. The transceiver will remain on
the busy channel until the signal is no longer present, at which time Scan resumes.
Note: To use Scan, there must be at least 2 channels added to the scanning sequence.
p S
riority cAn
If a Priority channel has been programmed, the transceiver will automatically
change to the Priority channel when a call is received on that channel, even if call
is being received on a normal channel.
• "P" appears on the display to indicate the Priority channel (depending on dealer setting).
t c
emporAry hAnnel
During scan, you can temporarily remove specific channels from the scanning
sequence by pressing the key programmed as Scan Delete/Add while Scan is
paused at the undesired channel. To temporarily remove a zone, press and hold
Scan Delete/Add while Scan is paused at a channel in the undesired zone.
• The channel/zone is no longer scanned. However, when scanning is ended and
restarted, the Scan settings return to normal.
S d /A
cAn elete
You can add and remove zones and/or channels to and from your scan list.
1 Select your desired zone and/or channel.
2 Press the key programmed as Scan Delete/Add to remove a channel or press
and hold the key for approximately  second to remove a zone.
• When a channel is added to scan, "cA" appears on the display. When it is removed,
"cd" appears on the display.
• When a zone is added to scan, "GA" appears on the display. When it is removed,
"Gd" appears on the display.
6
l
ockout
dd

SCAN