Save These Instructions - NewAir G56 Owner's Manual

12. To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
13. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, injury to persons or other damage to property.
14. This heater draws 20 Amps during operation. Be sure to use a dedicated 240VAC, 30A
circuit for the heater.
15. It is normal for the heater's plug and cord to feel warm to the touch. A plug or cord which
becomes hot to the touch or becomes distorted in shape may be a result of a worn
electrical outlet. Worn outlets or receptacles should be replaced prior to further use of the
heater. Plugging heater into a worn outlet/receptacle may result in overheating of the
power cord or fire.
16. Ensure the heater is on a stable, secure floor surface to eliminate the potential of tipping it
over.
17. Be sure that the plug is fully inserted into the appropriate receptacle. Please remember that
receptacles also deteriorate due to aging and continuous use: check periodically for signs of
overheating or deformations evidenced by the plug. Should this occur, do not use the
receptacle if deteriorated. CALL your electrician.
18. Check that neither the appliance nor the power cable has been damaged in any way during
transportation.
19. Make sure that no pieces of polystyrene or other packaging material have been left between
one element of the appliance and another. It may be necessary to pass over the appliance
with a vacuum cleaner.
20. When switching on the appliance for the first time, you may notice a slight odor which is
normal with new electrical appliances. Allow odor to dissipate by running appliance at full
power for about ten minutes. Make sure that the room in which the appliance is located is
well ventilated during this operation. This heater draws 20 Amps during operation. To
prevent overloading a circuit, do not plug the heater into a circuit that already has other
appliances working.
21. Do not run in locations when the heater will be left unattended for long periods of time.
22. Do not use attachments or filters. They are not recommended.
23. Always plug heater directly into a wall outlet/receptacle. Never use with an extension cord
or portable power tap (outlet/power strip). A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.

SAVE THESE INSTRUCTIONS

WARNING – RISK OF FIRE, DO NOT USE AS A
RESIDENTIAL OR HOUSEHOLD HEATER
CAUTION:
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
4