Programming A Two-Touch Memory; Dialing From A Two-Touch Memory; Call Waiting; Redial - Serene HD-50JV Operating Manual

Programming Two-Touch
Memories
1. While off-line, press key and then enter phone
number.
2. Press again, and then press "1" on the keypad to
save into a Two-Touch memory "A-1".
3. Repeat Steps 1 and 2 for other Two-Touch memories (A-2
to A-0).
Dialing from a Two-Touch
Memory
1. Lift handset, press and then an appropriate key from
"1" to "0" to select a Two-Touch memory. There will be
audio confirmation if the "Talking Keypad" feature is on.
2. Hang up handset to end the call.

Redial

1. Lift the handset to go on-line and then press
press key to go on-line and then press
2. Hang up the handset to end the call.
10

Call Waiting

While talking on the phone, a soft beep tone in the receiver
indicates a new call is waiting. You may answer this new call
by momentary press down on the hook switch and then let go.
This places the original caller on "hold" while you are talking to
the new caller.
At the end of the conversation, momentary press down on the
hook switch again reconnects you back to the original caller.

Pause Function

During one-touch (or two-touch) memory programming, press
key inserts a 3-second pause into the dialing sequence.
For example: 9 P 7 2 2 8 8 5 0 where "P" represents a
3-second pause. This pause is needed to access an outside
line on some business phone systems.
. (Or
).