Setting The Remote Control Code; Operating The Tv Of Sharp Using The Remote Control - Sharp BD-HP20S Operation Manual

Before Starting Playback
22
Setting the Remote Control
Code
• 3 types of remote control codes operate this Player:
RC-1, RC-2 and RC-3. If you operate this Player
by remote control along with another SHARP
Blu-ray Disc Player or DVD Player placed next to it
simultaneously, switching the remote control code
(both the Player and remote control) to one of the
signals (RC-1, RC-2 or RC-3) will let you operate
only with this Player.
• Make sure to set the Player and remote control to
the same remote code. You can not operate the
Player if they are not set to the same code.
Setting the Remote Control
Code of the Remote
Example: Setting the code to "RC-3".
1
Press and hold 3 fi rst and then B
on the remote control together for
more than 5 seconds.
2
Press B to turn off the player.
B
(POWER)
Setting the Remote Control
Code of the Player
3
Point the remote control at the
player, then press and hold the
DISPLAY button.
Remote control sensor
The display on the player changes
as shown below, and the player will
be set to the same number as the
remote control.
Example: Change "RC-1" to "RC-3".
Approx. 2 sec. later
Approx. 3 sec. later
If remote control does not work
Firstly, press B to turn on this player.
Press B on the remote control and check the
front panel display (RC-1, RC-2 or RC-3).
Set the remote control code according to the
display and press B to see if you can turn
on/off the Player.
Operating the TV of SHARP
Using the Remote Control
The Universal Remote Control may operate the
basic functions of the TV of SHARP.
TV function control
• TV Power: B
• TV Channel up/down: P r / s
• TV Volume up/down: i e/f
• TV-AV Selector: b