Table of Contents
Advertisement
2-8. FLAME SENSOR/
PILOT / IGNITOR
ASSEMBLY (Gas)
(Continued)
Figure 2-19
Figure 2-20
Figure 2-21
Figure 2-22
2-8
2. Remove the control panel and heat shield from control area.
Figure 2-19.
3. Disconnect the flame sense wire from ignition module.
Figure 2-20.
4. Using a 7/16" wrench, loosen the nut on the pilot tube and pull
tube from assembly. Figure 2-21.
5. Remove the two screws securing the assembly and pull
assembly from unit. Figure 2-22.
6. Now the flame sensor or or pilot assembly can be removed
from bracket.
Model OFE/OFG/OEA/OGA-341, 342
1003
Advertisement
Table of Contents
