Where To Install Your Mini-Compact System; Connecting Your System To The Power Supply; Inserting Remote Control Batteries; Connecting The Loudspeakers - Samsung MAX-A54U User Manual

Where to Install Your Mini-Com-
pact System
ENG
To take full advantage of your new mini-compact system, follow
these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
Connecting your System to the
Power Supply
Before plugging your system into a main socket, you must check
the voltage.
1
Plug the main lead into an appropriate socket.
2
Press the (STANDBY/ON) button to switch your mini-compact
system .
6

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
compartment cover (rear of the remote control) and pull the cover in
the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time,
remove the batteries to prevent corrosion.
The remote control can be used up to approximately 7
meters in a straight line. It can also be operated
at a horizontal angle of up to 45° from the remote control sensor.

Connecting the Loudspeakers

The loudspeaker connector terminals are located on the rear
of the system.
There are two terminals on the system:
left speaker (marked L)
right speaker (marked R)
To achieve the correct sound quality,insert those speaker con-
nector cables to the speaker connector terminals of the sys-
tem.
R L
R

Connecting to an External Source

The auxiliary input can be used to take advantage of the
sound quality of your mini-compact system when listening to
other sources.
Examples: A television
A video disc player
A Hi-Fi stereo video cassette recorder
To connect to the external source, the source must have an
audio output. In addition, you need an connection cable.
on the battery
1
Set the system to standby mode and disconnect it and the external
source from the main socket.
2
Connect AUX In on the MINI-COMPACT to Audio Out on the external
analog component.
Be sure to match connector colors.
3
Plug the system back into the main socket and press
STANDBY/ON to switch it on.
4 Select the AUX source by pressing AUX.
Result: AUX is displayed.
5
Switch the external source on.
6
Adjust the volume and balance as required:
Volume Equalizer
Example: You can watch a film and take advantage of stereo sound
provided that the original sound track is in stereo (as if you
were in a cinema).
3
L

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket
(75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 17 to tune into a radio station,
and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of
the system using a 75Ω coaxial cable (not supplied).
4
ENG
FM (75 )
ANTENNA RADIO
R L
FM (75 ) RADIO
ANTENNA
R L
7