Bunker Hill Security 69643 Owner's Manual page 6

Operating instructions
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
initial Battery Charging
Before the Security Light can operate
properly, the batteries need to be fully
charged. To charge the batteries:
1. Turn OFF the Power Switch.
2. allOW 3 DaYS OF Full SunliGht
to fully charge the batteries.
3. After charging, turn the Power Switch Auto. The light
will illuminate for a short time when first switched
on. This indicates that it is working properly.
power Switch
The Power Switch, located under the Battery
Housing of the Lamp has three settings:
OFF: Center position.
motion Detector Control Knobs
The Solar Powered Security Light has 3
different Control Knobs on the underside of the
Motion Detector Head. They control the Motion
Detector Head's sensor. They are sensitivity
to light (LUX), the light's duration (TIME) and
the sensor's sensitivity to motion (SENS).
nOte: After each adjustment, walk the detection
area to check the adjustment just made.
Page 6 For technical questions, please call 1-800-444-3353.
CautiOn
the unit Will nOt FunCtiOn
UNLESS:
The Solar Panel is first charged for
3 DAYS OF FULL SUN
with the SENSOR POWER OFF.
ON: Towards the Lamp. The lamp stays
on functioning as a normal light.
AUTO: Away from the Lamp. The light
will turn on automatically when motion is
detected by the Motion Sensor Head.
SENS TIME Adjusting Knob
Adjusting
Knob
SenS time
Underside of Motion
Detector Head
LUX
Adjusting
Knob
luX
Item 69643