Central Pneumatic 69704 Owner's Manual & Safety Instructions page 11

Heavy duty air paint spray gun
Table of Contents

Advertisement

Delayed or inadequate cleaning will permanently clog the Spray Gun.
10. Use the Pattern Knob to
adjust the spray pattern.
Turn Pattern Knob counterclockwise
(all the way open) to flatten the spray pattern.
Turn it clockwise for a round spray pattern
- see Figure E: Pattern Adjustment.
Flat/
Open
Figure E: Pattern Adjustment
Fluid Adjustment
11. Turn the Fluid Knob clockwise
until it is fully closed.
12. After setting up a piece of scrap
material, squeeze the Trigger in short
bursts while turning the Fluid Knob
counterclockwise to set the amount of fluid
- see Figure F: Fluid Adjustment.
Item 69704
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Round/
Closed
For technical questions, please call 1-800-444-3353.
Too Coarse
Correct
(Increase
air flow)
Figure F: Fluid Adjustment
If spray is too fine:
Reduce the air pressure or allow more paint
to come out by opening the Fluid Knob.
If spray is too thick (globs of paint):
Close the Fluid Knob slowly,
checking the pattern after each adjustment.
Too Fine
(Decrease
air flow)
Page 11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents