Checking And Filling Fuel; Engine Oil Change; Air Filter Element Maintenance - Predator 69675 Owner's Manual & Safety Instructions

Checking and Filling Fuel

WaRninG! tO PRevent SeRiOuS
injuRY FROm FiRe:
Fill the fuel tank in a well-ventilated area
away from ignition sources. If the engine is
hot from use, shut the engine off and wait
for it to cool before adding fuel.
Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
3. If needed, fill the Fuel Tank with 87
octane or higher unleaded gasoline.

engine Oil Change

CautiOn! Oil is very hot during operation and can
cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Place a drain pan (not included) underneath
the crankcase's drain plug.
4. Remove the drain plug and, if possible,
tilt the crankcase slightly to help drain
the oil out. Recycle used oil.
5. Replace the drain plug and tighten it.
6. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by threading it counterclockwise,
and wipe it off with a clean lint free rag.

air Filter element maintenance

1. Remove the air filter cover and the
air filter elements and check for dirt.
Clean or replace as described below.
2. Cleaning:
• For "paper" filter elements:
To prevent injury from dust and debris,
wear ANSI-approved safety goggles,
NIOSH-approved dust mask/respirator, and
heavy-duty work gloves. In a well-ventilated
area away from bystanders, use pressurized
air to blow dust out of the air filter. If this does
not get the filter clean, replace it.
Item 69675 / 69676
For Pump technical questions, please call 1-800-444-3353.
For engine technical questions, please call 1-800-520-0882.
note: Do not use gasoline containing more than
10% ethanol (e10). Do not use e85 ethanol.
note: Do not use gasoline that has been stored in a
metal fuel container or a dirty fuel container. it can
cause particles to enter the carburetor, effecting
engine performance and/or causing damage.
4. Replace the Fuel Cap.
5. Wipe up any spilled fuel and allow excess
to evaporate before starting engine. To
prevent FIRE, do not start the engine while
the smell of fuel hangs in the air.
Full level
note: Do not thread
the dipstick in when
checking the oil level.
7. Add the appropriate type of oil until the
oil level is at the full level. SAE 10W-30
oil is recommended for general use.
The SAE Viscosity Grade chart shows other
viscosities to use in different average temperatures.
8. Thread the Sae viscosity Grades
dipstick back
in clockwise.
CautiOn! Do
not run the
engine with too
little oil. The
5W-30
engine will be
permanently
-20 0
damaged.
average outdoor temperature
• For foam filter elements:
Wash the element in warm water and
mild detergent several times. Rinse.
Squeeze out excess water and allow it to dry
completely. Soak the filter in lightweight oil
briefly, then squeeze out the excess oil.
3. Install the new filter or the cleaned filter.
Secure the Air Cleaner Cover before use.
Full level
30
10W-30
20 40 60 80 100°F
Page 15