Checking And Filling Fuel; Engine Oil Change; Air Filter Element Maintenance - Predator 9000 Owner's Manual & Safety Instructions

Checking and Filling Fuel

WARNING! TO pREVENT SERIOUS
INJURY FROM FIRE:
Fill tank in a well-ventilated area away
from ignition sources. If the engine
is hot from use, shut the engine off and
wait for it to cool before adding fuel. Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
Note: Do not use gasoline containing more than
10% ethanol (E10). Do not use E85 ethanol.

Engine Oil Change

CAUTION! Oil is very hot during operation and can
cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Place a drain pan (not included) underneath
the crankcase's drain plug.
4. Remove the drain plug and, if possible,
tilt the crankcase slightly to help drain
the oil out. Recycle used oil.
5. Replace the drain plug and tighten it.
6. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by threading it counterclockwise,
and wipe it off with a clean lint free rag.
Full Level
7. Add the appropriate type of oil until the
oil level is at the full level. SAE 10W-30
oil is recommended for general use.

Air Filter Element Maintenance

1. Remove the air filter cover and the air filter elements
and check for dirt. Clean as described below.
2. Cleaning:
• For "paper" filter elements:
To prevent injury from dust and debris, wear
ANSI-approved safety goggles, NIOSH-approved
dust mask/respirator, and heavy-duty work gloves.
In a well-ventilated area away from bystanders,
use pressurized air to blow dust out of the air filter.
If this does not get the filter clean, replace it.
ITEM 59134
Full Level
For technical questions, please call 1-888-866-5797.
Note: Do not use gasoline that has been stored in a
metal fuel container or a dirty fuel container. It can
cause particles to enter the carburetor, effecting
engine performance and/or causing damage.
3. If needed, fill the Fuel Tank to about 1 inch
under the fill neck with 87 octane or higher
unleaded gasoline that has been treated with
a fuel stabilizer additive. Follow fuel stabilizer
manufacturer's recommendations for use.
4. Replace the Fuel Cap.
5. Wipe up any spilled fuel and allow excess
to evaporate before starting engine.
To prevent FIRE, do not start the engine
while the smell of fuel hangs in the air.
Note: Do not thread the dipstick in
when checking the oil level.
The SAE Viscosity Grade chart shows other
viscosities to use in different average temperatures.
SAE Viscosity Grades
5W-30
-20 0 20
Average outdoor temperature
8. Thread the dipstick back in clockwise.
NOTICE: Do not run the engine with too little oil.
Engine will not start with low or no engine oil.
• For foam filter elements:
Wash the element in warm water and mild
detergent several times. Rinse. Squeeze out
excess water and allow it to dry completely.
Soak the filter in lightweight oil briefly,
then squeeze out the excess oil.
3. Install the cleaned filter. Secure the
Air Cleaner Cover before use.
30
10W-30
40 60 80 100°F
Page 19