Connecting Headphones/Microphone
You can connect a set of headphones to your micro component system so that you
can listen to music or radio programmers without disturbing other people in the room.
The earphones must have a 3.5ø jack or an appropriate adapter.
65
Connect the headphones
to the PHONES jack on
the front panel.
•
The loudspeakers are no longer used to
output the sound.
Note
•
Prolonged use of headphones at a high volume may damage
your hearing.
•
HDMI AUDIO ON is converted to OFF when connected the
headphones.
•
When CD ripping,CD Audio can't be out.
Plug the microphone with a 6.3ø MIC
jack into microphone terminal.
•
Connect the Microphone.
•
Press the MIC VOL buttons to adjust the MIC level.
• Press the ECHO button to select ECHO1,ECHO2, and ECHO OFF.
• When connected a MIC,HDMI output is not available.
Cautions on Handling and Storing Discs
Small scratches on the disc may reduce sound and picture quality or cause breaks in
playback. Be especially careful not to scratch discs when handling them.
Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints will not
get on the surface.
Do not stick paper or tape on the disc.
Handling and Storing Discs
When you get fingerprints or dirt on the disc, clean it
with a mild detergent diluted in water and wipe with a
soft cloth.
•
When cleaning, wipe gently from the inside to the outside of the disc.
•
Note
Condensation may form if warm air comes into contact with cold parts
inside the player. When condensation forms inside the player, the player
may not operate correctly. If this occurs, remove the disc and let the
player stand for 1 or 2 hours with the power on.
ENG
66