Special Programming - Henny Penny HHC-990 Operator's Manual

4-3. SPECIAL PROGRAMMING

SP-1 Fahrenheit/Celsius
SP-2 Lock/Unlock
SP-3 Air Temperature Setpoint
303
This mode allows you to program the following:
SP-1 • Fahrenheit/celsius
SP-2 • Lock/unlock
SP-3 • Air temperature setpoint
SP-4 • Humidity setpoint
SP-5 • Proof air temperature
SP-6 • Proof humidity setpoint
SP-7 • Out of water tripp point
SP-8 • Clean water pan setpoint
SP-9 • System intialization
SP-10 • Audio volume
SP-11 • Audio tone
SP-12 • Audio effects
SP-13 • Language options
1. Press and hold the
shows in the display.
2. Press again, then "SP PROG" shows in display.
3. After 5 seconds, "ENTER CODE" shows in display.
4. Press
o "o
" F"or C" shows in the display.
5. Press the
6. Press and "SP-2, LOCK/UNLOCK PROGRAMMING'
shows in display, along with either "LOCK" or "UNLOCK".
7. Press to change lock the programming or unlock the
programming.
8. Press and "SP-3, AIRTEMP SETPOINT," and the
preset cabinet temperature shows in display.
9. Press to change the air temperature setpoint,
o o
140 F (60 C) minimum, 210
Model HHC-990
until "LEVEL 2", then "CLOCK SET"
and "SP-1, TEMP, UNITS" and
to change temperature units.
o o
F (99 C) maximum.
4-3