Where To Install Your Mini-Compact System; Connecting Your System To The Power Supply; Connecting The Loudspeakers - Samsung MAX-N75 Instruction Manual

Where to Install Your
Mini-Compact System
To take full advantage of your new mini-compact system, follow
these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 4 inches (10 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of the
system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
Disc 1
On/Standby
Game
Aux Demo
PTY
RDS
Display
Timer/
Clock
Band
TUNER
Rev Mode Deck 1/2
Counter Reset
Dubbing
Normal High
CD REC/Pause
Connecting your System to the
Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage.
1
Plug the main lead (marked AC Cord on the rear of the system) into
an appropriate socket.
2
Press the On/Standby button to switch your mini-compact system on.
Disc Change
Open/
Close
Disc 2 Disc 3
Volume
+
–
ower
Surround
CD TAPE
Moving Control Manual EQ /Enter
Mono/ST Program
Preset/Memory CD Repeat
S.BASS
EQ
REC/Pause Shuffle CD Synchro
3D Surround
Preset/Manual
(IMPEDANCE 6 )

Connecting the Loudspeakers

The loudspeaker connector terminals are located on the rear
of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the - terminals
1
To connect a wire to a terminal, push the tab as far as it will go:
To the right on the system
2
Insert the wire, up to the plastic sheathing, in the hole.
3
Push the tab back:
To the left on the system, until it clicks into place
To the top on the loudspeaker
Result: The wire is pinched and held firmly in place.
4
Repeat the operation for each wire.
<MAX-N72>
L
R
<MAX-N73>
L
R
<MAX-N75>
L
R
GB
7