Checking The Remote Controller - Samsung AQV09USeries User & Installation Manual

Checking the remote controller

• Point the remote controller towards the remote controller receiver of the indoor unit.
• When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit
indicator( ) appears on the remote controller display.
Remote controller buttons
SPi : Set the SPi function on/off
Smart Saver
Less energy usage makes your space
cool between the temperature range
of 24°C~30°C.
Operate in auto fan speed to
Temp hr. + -
Increase/Decrease the temperature by 1˚C.
Set the On Timer on.
Set the current time
Use 2
Auto clean function – Dry inside of the indoor
unit to get rid of odor.
• When you press [2
the functions on the remote controller as listed below.
On  Time Set
Timer
If you select the function under the button while the function of the button is switched by 2
the 2 F function is canceled.
nd
• Make sure that the water does not get to the remote controller.
8
MAX_XSA_IBIM_DB98-33747A_E.pdf
SPi
Turbo
cool quickly hr.
.
Filter
Reset
Display Auto
Clean
On Timer
Time Set
nd
function
Auto Clean
F] button, the indicator will be displayed on the remote controller and you can change
nd
Power
Mode
Set one of the 5 operating modes
(see pages 10~11 for instructions).
Quiet
Reduce noise generated from an indoor unit
during operation.
Air swing
automatically up and down.
Fan min.
min.
such as Auto/Low/Medium/High.
Filter Reset
This Button doesn't have any function.
However Beep sound will come out.
S et the
Set/Cancel
Set/Cancel the timer/
nd F button,
mode on.
mode .