Led Indicators; Shorten Sensor Unit Cable - Axis P1214 User Manual

AXIS P1214 Network Camera
Hardware Overview
NOTICE
NOTICE NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Resetting the product to factory default settings. See page 40.
• Connecting to an AXIS Video Hosting System service. See page 33. To connect, press and hold the button for
about 1 second until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 33. To connect, press and hold the button for
about 3 seconds.
Power connector - 2-pin terminal block for power input. Use a limited power source (LPS) with either a rated output power
limited to £100 W or a rated output current limited to £5 A.
I/O terminal connector - Use in applications for e.g. motion detection, event triggering, time lapse recording and alarm notifications.
In addition to an auxiliary power and a GND pin, the I/O terminal connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by
the VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The
output will show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for
example: PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and
the input becomes active (shown under System Options > Ports & Devices).

LED Indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Unlit
Power Green
Amber
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .

Shorten Sensor Unit Cable

The sensor unit is delivered with a 8 m (26 ft) cable.
To shorten the cable follow these steps:
Indication
Steady for connection to a 100 MBit/s network. Flashes for network activity.
Steady for connection to a 10 MBit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Steady during startup and when restoring settings.
Slow flash for failed upgrade.
No connection between sensor unit and main unit.
Normal operation.
Flashes green/amber during firmware upgrade.
5