Page 1
NOTE: Please read all instructions carefully before using this product Deluxe Power Tower Table of Contents SAG-71 Safety Notice Hardware Pack Assembly Instruction Parts List Warranty Ordering Parts Model SAG-71 Retain This Manual for Reference 100816 OWNER'S MANUAL ® IMPEX INC.
BEFORE YOU BEGIN ® Thank you for selecting the SA GEAR SAG-71 Power Tower by IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As the manufacturer, we are committed to provide you complete customer satisfaction.
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1.
WARNING LABEL PLACEMENT The Warning Label shown here has been placed on the Rear Base Frame. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
ASSEMBLY INSTRUCTION Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Do not tighten Nuts and Bolts until instructed to do so. B.) Attach one Base Frame (#1) to the Rear Base Frame (#10).
Page 8
STEP 2 (See Diagram 2) A.) Do not tighten Nuts and Bolts until instructed to do so. B.) Attach the Left Upright Beam (#2) onto the left Base Frame (#1). Secure it with two M10 x 3” Hex Bolts (#29), four Ø ¾” Washers (#34), and two M10 Aircraft Nuts (#32). C.) Attach the bracket on Left Upright Beam to Left Rear Support (#8).
Page 9
STEP 3 (See Diagram 3) A.) Attach the Chin-up Bar (#7) to the two Upper Uprights (#11). Secure them together with two M10 x 1 5/8” Hex Bolts (#22) and two Ø ¾” Washers (#34). B.) Cover the Hex Bolts with two Chin-up Covers (#15). DIAGRAM 3...
Page 10
STEP 4 (See Diagram 4) A.) Attach the two Upper Uprights (#11) onto Left & Right Upright Beam (#2 & #3). B.) Attach the Left Arm Support (#4) to the left Upper Upright and Left Upright Beam from front. Attach the Backrest Support Frame (#6) to the left Upper Upright and Left Upright Beam from Rear.
Page 11
STEP 5 (See Diagram 5) A.) Attach the Backrest Board (#13) to the Backrest Support Frame (#6). Secure it with two M8 x 5/8” Allen Bolts (#25) and two Ø 5/8” Washers (#35). B.) Attach two Arm Pads (#14) to Left & Right Arm Support (#4 & #5). Secure each Arm Pad with two M8 x 2 ½”...
PARTS LIST KEY NO. DESCRIPTION QUANTITY Base Frame Left Upright Beam Right Upright Beam Left Arm Support Right Arm Support Backrest Support Frame Chin-up Bar Left Rear Support Right Rear Support Rear Base Frame Upper Upright Dip Handle Backrest Board Arm Pad Chin-up Cover 2 ½”...
® IMPEX INC. LIMITED WARRANTY ® IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase.