Lennox LSS-35CN Care And Operation Instructions Manual page 13

INITIAL INSTALLATION CONSIDERATIONS
If the ceramic panels and logs are being installed for the first time, the
following paragraphs apply:
DO NOT attempt to install the logs until the appliance installation has
been completed, the gas line connected and tested for leaks and the
initial burner operation has been checked out.
Step 1. Remove the boxed ceramic panels on top of the appliance.
Handle panels carefully to prevent breakage.
Step 2. Remove the appliance front door.
Step 3. Cut and remove the nylon securing the log grate and the boxed
log set to the interior of the fireplace.
Step 4. Remove the logs from their packaging. Handle logs carefully
to prevent breakage.
Step 5. Remove the restraining strap from the grate tines. Remove the
grate from the interior of the fireplace.
CERAMIC PANEL, LOG AND GLOWING EMBER PLACEMENT
Step 1. Install the ceramic panels as shown in Figure 11. Panels should
be placed in the order shown.
A. Tilt and slide the top edge of the back panel toward the rear, behind the
baffle and pivot the bottom inward to position it vertically as shown.
B. Align and slide the left and right bottom panels inward as shown.
Slide the front panel toward the back, until it touches the left and right
panels. Be sure there are no gaps between the panels.
C. Slide the left and right side panel inward with the orientation of the
marked "L" and "R" in their proper position as shown.
Figure 9
Glowing Embers (Rockwool)
Figure 10
Step 2. Position the individual logs as shown in Figures 12 and 13.
Logs should be placed in the order shown.
Step 3. Separate the Glowing Ember (Rockwool) into pieces about
the size of a quarter (see Figure 9 ). Keep the pieces fluffed up, not
matted. Distribute these pieces over the front burner and between the
log as shown in Figure 10. Do not use more than is necessary. When
properly positioned, the Glowing Embers will cover approximately 85%
of the front burner.
Note: This appliance is provided with enough Glowing Embers for several
applications, do not feel compelled to use all that is in a new bag. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (Catalog Number 88L53).
Proper log and twig placement is critical to encourage outstanding
flame appearance and prevent sooting. When positioned properly
as shown, twigs will be positioned between flame peaks and will not
impinge any flames.
Catalog Number
• DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• The size and position of the log set was engi-
neered to give the appliance a safe, reliable
and attractive flame pattern. Any attempt to use
a different log set in the fireplace will void the
warranty and will result in incomplete combus-
tion, sooting, and poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to
the appliance before you install grate, volcanic
stone, vermiculite, embers and logs.
• This appliance is not designed to burn wood.
Any attempt to do so could cause irreparable
damage to the appliance and prove hazardous
to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in
soot and/or excessive production of carbon mon-
oxide (CO), a colorless, odorless, toxic gas.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
REFERENCE
Firebox Accessories / Parts
Model Number
88L53 FGE Bag of Glowing Embers
80L42 FDVS Bag of Decorative Volcanic Stone
WARNING
Description
13