Advertisement

Installation, Operating, Maintenance
and After Sales Manual.
HI-LINE LV Fan Convector
Model: 7-4
heatingthroughinnovation.
Product Serial Number:
Please leave this manual with the end user.
Part Number: 1370058
Issue 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7-4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Myson 7-4

  • Page 1 Installation, Operating, Maintenance and After Sales Manual. HI-LINE LV Fan Convector Model: 7-4 heatingthroughinnovation. Product Serial Number: Please leave this manual with the end user. Part Number: 1370058 Issue 3...
  • Page 2: Table Of Contents

    Contents General Information Heating System Design Unit Selection/Sizing Location Preparation Fixing Water Connections Electrical Connection Commissioning Procedure 10.0 Technical Data 11.0 Operating Instructions 12.0 Troubleshooting 13.0 Maintenance...
  • Page 3: General Information

    HI-LINE LV Fan Convector 1.0 General Information l This HI-LINE LV fan convector is designed for wall-mounted l This unit is fitted with a 12V transformer that enables the unit installation with a maximum installation height of 2.13m to to be fitted in a bathroom. The unit must be positioned in the underside of the unit and a minimum clearance between accordance with local or national wiring regulations.
  • Page 4: Preparation 04

    HI-LINE LV Fan Convector 5.0 Preparation Before proceeding with the installation, unpack the carton 3. Instruction manual. contents and check against the checklist below: 4. Warranty card. 5. Fixing kit (rubber mounts, cable gland and equipotential bond 1. HI-LINE LV unit. pipe clamp).
  • Page 5: Electrical Connection

    HI-LINE LV Fan Convector 8.0 Electrical Connection WARNING: The electrical installation must comply with local or national wiring regulations. l This unit is supplied with a 2m long mains cord. Room Thermostat - if a remote room thermostat is required to control the fan convector, remove the link between T1 and l A fused electrical spur with a maximum 3A fuse and a switch T2 on the terminal block and connect a suitable bimetallic...
  • Page 6: Technical Data

    12.0 Troubleshooting Once installed this fan convector becomes part of a complete Note: If you call out MYSON Service to a fault detailed opposite, heating system that will generally include a boiler, pump, other or to repair a fault caused by incorrect use, a call out charge will emitters such as radiators and fan convectors, and a number of be made.
  • Page 7: Maintenance

    If the fan convector is still faulty after checking the above, call your installer or MYSON Service. Common Installation Faults heat, and the heating system must be correctly designed to provide adequate flow of hot water to the unit (refer to section For optimum performance, this unit must be correctly sized to 2).
  • Page 8 0845 402 3434, 0191 491 7568, sales@myson.co.uk, www.myson.co.uk heatingthroughinnovation. After Sales Service: MYSON Service, Somerden Road, Hull, East Yorkshire HU9 5PE T: 01482 713927, F: 01482 789056, service.convectors@myson.co.uk Spare parts and technical help on all Convector products are available from MYSON Service.

Table of Contents