Chicago Electric 66182 Set Up And Operating Instructions Manual page 3

matching outlets will reduce risk of
electric shock.
Avoid body contact with grounded
b.
surfaces such as pipes, radiators,
ranges and refrigerators. There is
an increased risk of electric shock if
your body is grounded.
c. Do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
d. Do not abuse the power cord.
Never use the cord for carrying,
pulling or unplugging the power
tool. Keep the cord away from
heat, oil, sharp edges or moving
parts. Damaged or entangled cords
increase the risk of electric shock.
e. When operating a power tool out-
doors, use an Extension cord (not
included) suitable for outdoor use.
Use of a cord suitable for outdoor use
reduces the risk of electric shock.
f. If operating a power tool in a damp
location is unavoidable, use a
ground Fault circuit Interrupter
(gFcI) protected supply. Use of
a GFCI reduces the risk of electric
shock.
3. personal safety
a. Stay alert, watch what you are do-
ing and use common sense when
operating a power tool. Do not use
a power tool while you are tired
or under the influence of drugs,
alcohol or medication. A moment
of inattention while operating power
tools may result in serious personal
injury.
b. Use personal protective equip-
ment. Always wear ANSI-ap-
proved safety goggles. Safety
SKU 66182 For technical questions, please call 1-800-444-3353.
equipment such as NIOSH-approved
dust maskrespirator, non-skid safety
shoes, hard hat, or hearing protection
used for appropriate conditions will
reduce personal injuries.
prevent unintentional starting.
c.
Ensure the power Switch is in the
off-position before connecting to
power source and/or picking up or
carrying the tool. Carrying power
tools with your finger on the Switch or
energizing power tools that have the
Switch on invites accidents.
remove any adjusting key or
d.
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
e. Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
f. Dress properly. Do not wear loose
clothing or jewelry. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewelry or long hair can be caught in
moving parts.
g. Only use safety equipment that
has been approved by an appropri-
ate standards agency. Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breath-
ing protection must be NIOSH-ap-
proved for the specific hazards in the
work area.
4. power tool use and care
a. Do not force the power tool. Use
the correct power tool for your ap-
plication. The correct power tool will
Page 3