SNOWJOE HJ600C Operator's Manual

Form No. S J-HJ600C-880E
A Division of Snow Joe, LLC
OPERATOR'S MANUAL
IMPORTANT!
Safety instructions
All Operators Must Read These
Instructions Before Use
General Power Tool Safety Warnings
WARNING
Read all safety warnings and all
instructions
Failure to follow all warnings, and
instructions may result in electric shock, fire or serious injury.
Save all warnings and instructions for
future reference
To use this toot properly, you must observe all safety warnings,
assembly, operating and maintenance instructions in this
manual. Always follow regulations regarding use in the area
the tool is being used. Do not allow children, or a person
physically incapable of operating the tool.
Always be aware, and take precautions against, potential
hazards during use and maintenance of the tool. These
include, but are not limited to, the following:
• Contact with the blade.
Kickback.
Blade fracture.
Catapulting of blade pieces.
Damage to eyes if effective safety glasses or protective
shields are not worn.
Damage to ears if effective ear defenders are not worn.
,_ WARNING
When using power tools, basic safety precautions should
always be taken to reduce the risk of fire, electric shock, and
personal injury. Always follow the safety instructions in this
manual.
1. Keep the work area clean and tidy. Cluttered work
areas and benches invite accidents and injury.
2. Consider the environment in which you are working.
Do not use power tools in damp or wet locations. Keep
the work area well lit. Do not expose power tools to
rain and high humidity. Do not use power tools in the
presence of flammable liquids or gases.
© 2010 by Snow Joe, LLO
All rights reserved. Original instructions.
3=
4=
5=
6=
7=
8=
9=
10.
11.
12.
13.
14.
Keep visitors away from the work area. All visitors
and onlookers, especially children and infirm persons
should be kept well away from where you are working.
Do not let others in the vicinity make contact with the
tool.
Store tools safely. When not in use, tools should be
stored in a dry, high place or locked up out of reach.
Do not force the tool. The tool will do the job better
and safer working at the rate for which it was
designed.
Use the correct toot for the job. Do not force small
tools or attachments to do the job best handled by a
heavier duty tool. Never use a toot for a purpose other
than that for which it was intended.
Dress correctly. Do not wear loose clothing or jewelry.
They can be caught in moving parts. Rubber gloves
and non-slip footwear are recommended when working
outdoors, tf you have long hair, wear a protective hair
covering.
Use safety accessories. Safety glasses and ear muffs
should always be worn.
Do not overreach. Keep your footing secure and
balanced at all times.
Look after your tools. Keep tools clean and sharp for
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Keep
tool handles dry, clean and free from oil and grease.
Disable idle tools. Remove the battery from the tool
before servicing and when the toot is not in use.
Avoid unintentional starting. Make sure that the
switches are in the OFF position before attaching the
battery.
Stay alert. Watch what you are doing. Use common
sense. Do not operate a power tool when you are tired.
Check for damaged parts. Before using a tool, check
that there are no damaged parts, tf a part is slightly
damaged, carefully determine it will operate properly
and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage
of parts, proper mounting and any other conditions
that may affect the operation of the tool. A guard or
other part that is damaged should be properly repaired
or replaced by an authorized service facility, unless
otherwise indicated in this manual. Defective switches
must be replaced by an authorised service facility. Do
SAVE THESE INSTRUCTIONS