How To Add The Fabric Softener; How To Put The Detergent In; Water Supply Connector Filter - Samsung WASHING MACHINE User Manual

☞ IN CASE OF GENERAL WASHER
1. After pressing the joint ring, insert to the drain hose.
2. After directing the drain hose to a drain, join to the
drain-outlet of the washing machine.
3. Be sure to join them tightly by pressing the joint ring
and pushing it into the drain-outlet.
• The length of drain hose is adjustable so that you
can extend the length appropriately.
HOW TO CHANGE THE DRAIN HOSE DIRECTION
• The handle of joint ring is pressed to pull out the drain hose.
Change the direction of the drain hose and follow the above
guideline again.
CAUTIONS WHEN INSERTING THE DRAIN HOSE
1. Don't exceed more than 3m when the drain hose
is used by connecting whth other hoses.
2. Be careful to drain water out at the end of the
drain hose.
3. The doorsill shoudn't be more than 5cm.
4. Don't install the drain hose underneath the wash
machine.

■ HOW TO ADD THE FABRIC SOFTENER

• When a proper amount (one time does) of fabric softener is
stored in the softener inlet, it is automatically put in at the last
rinsing cycle.
• Do not use detergent, bleach or starch into the Softener
Inlet.
• Using too much softener may produce unsatisfactory
results.
• Do not open the lid during the Spin Dry cycle. If added too
early, its effectiveness will decrease.
• Do not leave the softener into the Softener.
Dispenser for a long time. Because softner became stiff.
drain-outlet

■ HOW TO PUT THE DETERGENT IN

1. Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim
over the box.
Less than 3 m
CAUTION : If softener is stored over the above base line, it may flow down at any

■ WATER SUPPLY CONNECTOR FILTER

Less than 3 m
Less
1. Pull out the filter and
than
wash well.
5 cm
- 12 -
Detergent Device
Put the detergent in
proportion to Water
level
Softener Device
Softener
baseline
time.
inlet water
valve
2. Pull in the filter and
connect the hose to
the inlet water valve
tightly.
3. Check if there is a
leakage.
Note to tighten up the
connector.