Connecting The Water Supply Hose; Assembling The Rat Protection Panel; How To Connect The Drain Hose - Samsung WASHING MACHINE User Manual

■ CONNECTING THE WATER SUPPLY HOSE

1. Remove the adaptor from the water supply hose.
2. First, using a "+" type screw driver, loosen the four screws
on the adaptor. Next, take the adaptor and turn part(b)
following the arrow for gap about 5 mm between them.
3. Connect adaptor to the water tap by tightening the
screws firmly. Then, turn part(b) following the arrow and
put (a) and (b) together.
4. Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c)
is released, the hose is automatically connected to the
adaptor making a 'click' sound.
5. Connect the other end of the water supply hose to the
inlet water valve at the back of the washer. Screw the
hose clockwise all the way in.
5-1. Connect the other end of the water supply hose to the
inlet water valve at the top of the washer. Screw the hose
clockwise all the way in.
☞ If the water tap is a screw type, assemble a water supply
hose that fits to the tap as shown..
After completing connection, if water leaks from the hose, then repeat
the same steps.
Note!
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring before
inserting the faucet into the adaptor.
Note : The appliance is to be connected to the water mains using
new hose-sets and that old hose-sets should not be used.

■ ASSEMBLING THE RAT PROTECTION PANEL

Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with
screw to the base as shown in the figure.
1. Insert the sound absorbing panel to the assembling hole
on back side to the end
a
b
2. If you have difficulty inserting the panel lift up the
washer a little and insert it.
* THE PROTECTION PANEL IS NOT APPLIED IN SOME
MODELS.
c

■ HOW TO CONNECT THE DRAIN HOSE

☞ IN CASE OF PUMP-DRAINED WASHER
Take out the cap-hose and
connect the outlet-hose.
cap-hose
Be sure to join tightly the drain
hose into the drain-outlet on
the side of the machine.
- 11 -
Rear-side
Be sure to join tightly the drain hose into the
drain-outlet on the back of the machine.
Install the drain hose in the position of about
90~100cm above the ground.