How To Put The Detergent In; How To Add The Fabric Softener; Water Supply Connector Filter - Samsung WA90F4 User Manual

installation & maintenance
HOW TO PUT THe DeTeRGeNT IN
1. Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim
over the box.
HOW TO ADD THe FABRIC SOFTeNeR
Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the
reverse direction.
• When a proper amount (one time does) of fabric softener is stored in the softener
inlet, it is automatically put in at the last rinsing cycle.
• Do not use detergent, bleach or starch into the Softener Inlet.
• Using too much softener may produce unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness
will decrease.
•
Do not leave the softener into the Softener Dispenser for a long time. Because
softner became stiff.
WATeR SUPPLy CONNeCTOR FILTeR
1. Pull out the filter and wash well.
2. Pull in the filter and connect the hose to the inlet water
valve tightly.
3. Check if there is a leakage.
Note to tighten up the connector.
18_installation & maintenance
WA90F4-02723G-02_EN.indd 18 2012-06-01 6:50:57