American Standard Hampton T980.702 Installation Instructions

DECK-MOUNT BATH FILLER TRIM KIT
with
EverClean™ Finish
Congratulations on purchasing your American Standard
faucet with EverClean finish found only on American
Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Required tools
Phillips Screwdriver
Channel Locks
1
SPOUT INSTALLATION
Complete FINISHED DECK before trim installation.
Turn off the water supplies.
Remove the GUARDS (1) from the VALVES (2). Remove the
GUARD (3) and 1/4" PLUG (4) from the SPOUT SHANK (5).
The SPOUT SHANK (5) height should be 1" to 1-1/2" above the
FINISHED DECK. Cut the SPOUT SHANK (5) if necessary. Remove all
burrs and bevel the end of the shank. Failure to do so may
damage the SPOUT O-ring during installation and cause water
leakage.
Drill a 3/16" hole in the finished deck. See TEMPLATE for location.
3/16" DRILLED
HOLE
Lubricate the SPOUT ADAPTER O-RING (6) and
SPOUT O-RING (7).
Push SPOUT ADAPTER (8) on SPOUT SHANK (9)
and align slot in SPOUT ADAPTER (8) with 3/16"
drilled hole.
Tighten SPOUT ADAPTER SET SCREW (10) securely
with 4mm HEX KEY (11).
Remove the PLUG BUTTON (12) from the SPOUT (13).
Position the RUBBER RING (14) in the groove in
the base of the SPOUT (13). Push the SPOUT (13) down
onto the SPOUT ADAPTER (8) and tighten the
SET SCREW (15) securely with the 5mm HEX KEY (16).
Insert the PLUG BUTTON (12) into the SPOUT (13).
Screwdriver
Drill with
3/16" bit
Hacksaw
SPOUT
SHANK
FINISHED
DECK
Installation
Instructions
T980.702
T980.712
T980.722
T980.732
4
5
1
2
FINISHED
DECK
19.8mm
(23/32")
FRONT
6
11
8
10
7
9
3/16" DRILLED
HOLE
GROOVE
14
13
Certified to comply with ANSI A112.18.1
U.S. Patent No. D403,750
M 9 6 8 6 5 5 R e v. 1 . 1
3
1
REMOVE ALL
BURRS AND
2
BEVEL
1"- 1-1/2"
8.4mm
(21/64")
3/16" DIA. HOLE
18.6mm DIA.
(47/64")
SPOUT SHANK
TEMPLATE FOR
SPOUT ROLL
PIN LOCATION
16
12
15
SPOUT
O-RING
13
8