First Switching-On; Use Of The Machine; Machine Statuses; Manual Switching-On - Saeco IDEA Idea Instruction And Maintenance Manual

11 - FIRST SWITCHING-ON

- Fill the hopper (6) with the selected coffee beans blend.
Be sure the coffee does not contain foreign bodies which
could be dangerous for grinders.
- Check if the removable components (13 and 16) are in the
right position and if the door (15) is closed.
If they are not, when the machine is switched-on, the display
will indicate which component is in the wrong position.
- Turn the all-pole switch on "I".
- Switch on the machine through the switch (18);
the message "WARMING UP" will be displayed.
- When the message "READY FOR USE" is displayed :
- Adjust the brew group (22) to obtain the suitable height
depending on the container used (Pr. 8.4).
- Place one or two containers under the brew group.
- Select the beverage and press the corresponding button.
Although buttons are previously programmed on a
standard base, check your beverage has the selected
features. If not, they must be reprogrammed (Pr. 12.6).

12 - USE OF THE MACHINE

Read carefully this brochure until you get a good
understanding of the machine, before starting to operate
it.
After a long time of machine inactivity, read the previous
paragraph "First switching-on" before re-operating
the machine.
12.1

Machine statuses

With regard to the power supply, the machine can have the
following statuses:
Off and electrically insulated
- Main switch (18) and all-pole switch on the "0" position
(or plug disconnected).
- Only the memory for the programmed data storing is enabled.
On
- Main switch (18) and all-pole switch on the "I" position (or
plug connected).
- All the functions are enabled and the display (8a) is on.
In standby mode (machine switched off but not electrically
insulated):
- Main switch (18) is on "I" position.
- The following functions are enabled: "AUTOM. SWITCHING-
ON", "ANTI-FREEZING", if selected, and "CLOCK", as
well as the display and the memory for the programmed data
storing.
- The display's backlight is off.
12.2

Manual switching-on

This switching-on is necessary when the machine is in the "off
and electrically insulated" status (Pr. 12.1). Proceed as
explained is Pr. 11 excluding, in case, the beverage brewing
check.
12.3 Programmed automatic
switching-on
The machine has to be on "STANDBY" and the function "AUTOM.
SWITCHING-ON" has to be enabled.
The machine will automatically switch-on at the programmed time.
12.4

Stand-by temporary switching-on

Manual switching-on when the machine on "STANDBY".
Press and hold the button
The machine will automatically return on "STANDBY", 60
minutes after the last operation.
English
for 3 seconds.
Espresso Italia PTY LTD
www.espressoitalia.com.au
Freecall 1300 660 976
155