Option Buttons; Delay Wash; Drain And Spin; Control Lock - Kenmore 796.2900 Series Use & Care Manual

OPTION BUTTONS
DELAY WASH
Once you have selected the cycle and
Delay Wash other settings, press this button to delay
the start of the wash cycle. Each press
of the button increases the delay time by one hour, for
up to 19 hours. Once the desired delay time is set, press
the START/PAUSE button to start the delay time.
NOTE: If the START/PAUSE button is not pressed to
begin the delay time, the washer will automatically shut
off: after four minutes.
DRAIN & SPIN
Use this option to drain the water from
Drain & Spin the tub and spin out the clothes. This
Control Lock
can be used, for example, if the wash
cycle is interrupted by a power failure. The spin speed
can be adjusted by pressing the DRAIN & SPIN button.
i_ Press the START/PAUSE button to turn on the washer.
O Press the DRAIN & SPIN button.
O Press the SPIN SPEED button to select the desired
spin speed. Selecting NO SPIN is not allowed.
O Press the START/PAUSE button.
CONTROL LOCK
Use this option to disable the controls. The
Draincootro_ &LockSpin washer can only be locked during a cycle.
This feature can prevent children from
changing cycles or operating the machine. Once the control
lock is set, it must be deactivated before any controls, except
the power button, can be used. Once the washer has shut off:,
the power button will allow the machine to be turned ON, but
the controls will still be locked. When the controls are locked,
LL will display alternately with the estimated time remaining.
Pressand hold the DRAIN & SPIN button for five seconds to
activate or deactivate CONTROL LOCI<.
SPECIAL DRAIN FEATURE
This washer is equipped with a special feature that is
designed to make your washer as safe as possible, if
the washer is paused or shut off: while there is still water
in the tub, the water will drain after four minutes. This
helps keep children safe by reducing the possibility of
water remaining in the tub. if the washer is shut off: for
three minutes, while there is still water in the tub, an
alarm will sound to notify you that the washer is about
to drain the water from the tub. The washer can be
restarted any time before the drain begins, if the washer
is paused for four minutes, the display will shut off: and
all cycle settings will be lost. Three minutes after the
control shuts off:, the alarm wili sound to notify you that
the washer is about to drain the water from the tub. The
washer can be turned on and another cycle may be
started before the drain begins.
if no action is taken, the d_- error code will display
and the water will drain from the tub. Once the washer
begins draining the water, the controls are disabled and
the drain process cannot be interrupted. Once the water
is completely drained, the washer will shut off:.
NOTE: In the unlikely event that the washer experiences
a problem that causes an error code to be displayed,
the washer will still sound the alarm after three minutes
and drain after four minutes. However, only the original
error code will be displayed.
22