Kenmore 796.2900 Series Use & Care Manual page 9

CONNECTING THE WATER LINES
* IMPORTANT: Use new hoses when installing the washer. Do
NOT reuse old hoses.
* IMPORTANT: Use ONLY the inlet hoses provided with this
washer. Aftermarket hoses are not guaranteed to fit or function
correctly. Other hoses may not tighten correctly and could cause
leaks. Subsequent damage to product or property win not be
covered under the terms of the product warranty.
* Water supply pressure must be between 14.5 psi and 116 psi
(100-800 kPa). If the water supply pressure is more than 116 psi° a
pressure reducing valve must be installed.
* Periodically check the hose for cracks, leaks, and wear_ and
replace the hose if necessary.
* Make sure that the water lines are not stretched_ pinched_
crushed_ or kinked.
* The washer should never be installed or stored in a location
subject to freezing temperatures. Damage to the water lines and
internal mechanisms of the washer can result. If the washer was
exposed to freezing temperatures prior to installation, allow it to
stand at room temperature for several hours before use and check
for leaks prior to operation.
3.Always run a gallon or two of water through each
inlet hose to flush dirt, scale and other debris out
of the water lines. Doing so will help prevent future
problems with clogged filter screens, and will also
allow you to verify which hose is hot and which
is cold.
_'_ Water Hose
(to water inlet
on washer) _
Rubber Seal
Rubber Seal
Water Hose
(to tap)
J
I. Inspect the threaded fitting on each hose and make
sure there is a rubber seal in place in both ends.
Water
2. Connect the water supply hoses to the HOT and
COLD water faucets tightly by hand and then tighten
another 2/3turn with pliers.
. J
4. Attach the (red) hot water line to the hot water inlet on
the back of the washer. Attach the (blue) cold water line
to the cold water inlet on the back of the washer.
Tighten the fittings securely. Turn ON both faucets all
the way and check for leaks at both ends of the hoses.
NOTE: Be careful not to cross-thread the hose fittings.
This will damage the valve and could result in property
damage from leaks.