Led Indicators; Led Indicators Of Ge-2032R - Ovislink Air Live GE-2032R User Manual

3

LED Indicators

3
LED Indicators
GE-2032R comes with six LED indicators on the backplane of the adapter. LED indicators
inform you about the network status as shown in the Fig. 3-1.
If you experience any problem with the adapter, first check the followings:
the appropriate driver is loaded
the proper cable is connected to the RJ-45 port of the adapter
the switch should complies with the 10/100/1000BASE-TX specifications.
You should make sure that all the above requirements are met, then check the LEDs again to
make sure the connection is valid and working.

LED indicators of GE-2032R

The NIC supports full duplex at 10/100/1000BASE-TX. If the switch supports NWay feature
and full duplex, the GE-2032R NIC automatically runs in full duplex.
If there is a problem with the connection, first check the network cable for possible breach. If
that does not resolve the problem, try to replace the cable.
10M/ACT:
Flashing indicates transmission activities.
100M/ACT: Light up to indicate a 100Mbps connection has been established.
Flashing indicates transmission activities.
1000M/ACT: Light up to indicate a 1000Mbps connection has been established.
Flashing indicates transmission activities.
FDUP:
means it is operating in Half Duplex mode. Flashing to indicate collisions.
For details information on LED color and status, please view the LED Table on the
next page.
100M/ACT
1000M/ACT
Fig. 3-1 LED indicators of GE-2032R
Light up to indicate a 10Mbps connection has been established.
Light up to indicate the port is operating in Full Duplex Mode. Off
- 10 –
FDUP
10M/ACT
OvisLink GE-2032R User's Guide