Step 2. Connect The Card To The Network; Step 3. Configure Your Network; Fig.2-2 Connecting The Network Cable To The Rj-45 Gigabit Port - Ovislink Air Live GE-2032R User Manual

Step 2. Connect the Card to the network

You must connect the NIC to the network before installing the network driver. To connect the
GE-2032R NIC to the network cable, follow these steps:
1. Connect the network cable to the RJ-45 Gigabit port on GE-2032R NIC, as shown in Fig.
2-2.
2. Connect the other end of the network cable to a 10BASE-T or a 100BASE-TX network
port.
3. Check the LEDs, as shown in Fig. 3-1a, Fig. 3-1b.
After installation of the network card, and you are now ready to install the network driver.

Fig.2-2 Connecting the Network Cable to the RJ-45 Gigabit Port.

Please See Chapter 3 for more LED information.

Step 3. Configure your Network

The NIC provides one RJ-45 Gigabit port for connecting to 10/100/1000BASE-TX Fast
Ethernet network. The NIC will automatically sense the transmission mode of the connection.
For a detailed description of the connection type, please refer to the followings:
Connecting to 1000BASE-T Gigabit Ethernet Network
To connect the Gigabit NIC to a 10/100/1000BASE-TX Gigabit Ethernet network, you need a
twisted-pair Category 5 cable with RJ-45 connectors. The connection distance is up to 100
meters maximum. Follow the steps below to connect to Ethernet/Fast Ethernet/Gigabit
Ethernet network:
1. Plug one end of the cable into the RJ-45 Gigabit port of the NIC.
2. Plug the other end of the cable into a Gigabit port of a Gigabit Ethernet Switch (such as
Live-GSH8T) or a high-performance server with a gigabit RJ-45 port.
2
8
OvisLink GE-2032R User's Guide
Hardware Installation