Download Print this page

Bionaire BSF152RC Instruction Manual page 2

Remote control stand fan

Advertisement

BSF152RC_07EM1.qxd
10/22/07
4:08 PM
Page 2
FAN SAFETY
PLEASE READ AND SAVE
THESE IMPORTANT
SAFEGUARDS
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be taken including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction
manual.
3. To protect against electrical shock do not immerse
unit, plug or cord in water or spray with liquids. Plug
the appliance directly into a 120V AC electrical outlet.
4. Close supervision is necessary when any appliance is
used by or near children.
5. Unplug from outlet when not in use, when moving fan
from one location to another, before putting on or
taking off parts and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate in the presence of explosive and/or
flammable fumes.
8. To avoid fire hazard, NEVER place the cord under
rugs or any parts near an open flame, cooking or
other heating appliance.
9. Do not operate any appliance with a damaged cord or
plug after the appliance malfunctions, or has been
dropped/damaged in any manner.
10.The use of attachments not recommended or sold by
the appliance manufacturer may cause hazards.
11.Do not use outdoors.
12.Do not let the cord hang over the edge of a table,
counter or come in contact with hot surfaces or leave
exposed to high traffic areas.
13.To disconnect, grip plug and pull from wall outlet.
Never yank on cord.
14.Always use on a dry, level surface.
15.Do not operate fan until fully assembled with all parts
properly in place.
16.This product is intended for household use ONLY and
not for commercial or industrial applications.
PLEASE SAVE THESE
INSTRUCTIONS
CONSUMER SAFETY INFORMATION
THIS APPLIANCE HAS A POLARIZED
AC (alternating current) PLUG (one blade
is wider than the other). To reduce the
risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it is still does not fit, contact a qualified
electrician to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
The length of the cord used on this product was selected
to reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical
FIGURE 1
G
H
Q
P
A B
C
D
E
F
O
I
J
Osc.
On/Speed
K
Mode
Timer
Off
Q
L
M
N
A. Logo Plate
J. Height Adjustment Ring
B. Front Grill
K. Lower Pole
C. Fan Blade Cap
L. Base
D. Fan Blade
M. Base Weight
E. Rear Grill Mounting Nut
N. Base Weight Nut
F.
Rear Grill
O. Thumbscrew
G. Motor Shaft
P. Control Panel
H. Motor Housing
Q. Remote Control
I.
Upper Pole
rating of the extension cord must be equal to or greater
than the rating of the fan. Care must be taken to arrange
the extension cord where it cannot be pulled on by
children or accidentally tripped over.
ASSEMBLY INSTRUCTIONS
1. Screw the Lower Pole into the Base.
2. Secure the Base Weight to the threaded end of the
Extension Pole with the Base Weight Nut. Refer to
Figure 2.
3. Slide the Control Panel with the Motor Housing over
the Upper Pole. Tighten the Thumb Screw. Refer to
Figure 3.
4. Secure the Rear Grill to the Motor Housing by
tightening the Rear Grill Nut. Refer to Figure 4 for the
correct positioning of the Rear Grill to the Motor
Housing.
5. Secure the Fan Blade to the Motor Shaft by tightening
the Fan Blade Cap. Refer to Figure 5 for correct
alignment of the Fan Blade to the Blade Shaft.
6. Secure the Front Grill to the Rear Grill by snapping the
Front Grill into the clips around the perimeter of the
Rear Grill.
Note: The Remote Control can be stored in the back of
the Control Panel.
OPERATING INSTRUCTIONS
1. Speed Control, press the On/Speed button:
1st – Low, 2nd – Medium, 3rd – High
2. To turn the fan off, press the Off button.
3. To turn the oscillation on or off, press the Oscillation
Button located on the Control Panel.
Timer:
Your fan is equipped with a timer feature that automatically
turns the fan off after a programmed amount of time.
To set the timer, press the Timer button:
FIGURE 3
FIGURE 2
K
L
P
O
I
J
N
M
1st – 1 hour, 2nd – 2 hours, 3rd – 4 hours, 4th – 8 hours,
5th – Timer off
Sleep/Breeze Mode:
Your fan is equipped with a sleep/breeze mode. The
sleep/breeze mode simulates a natural breeze by
automatically changing the speeds of the fan.
Press the Mode button:
1st – Breeze, 2nd – Sleep, 3rd – Breeze/Sleep, 4th –
Sleep/Breeze mode off
ADJUSTMENT INSTRUCTIONS
Height Adjustment: Loosen the Height-Adjustment ring,
adjust the pole to the desired height, and tighten the
Height-Adjustment ring to lock into place.
Tilt Adjustment: Gently, move the fan head to the desired
angle.
FIGURE 4
E
F
FIGURE 5
C
D

Advertisement

loading