Timer Mode - American DJ Fog Fury 3000 User Instructions

Fog Fury 3000
A.XXX -
DMX Address Setting. ("XXX" represents the dis-
played DMX address.)
1. Press the either the MENU, UP, or DOWN buttons until
"A.XXX" is displayed. "XXX" represents the current address that
is displayed
2. Press the UP or DOWN buttons to change/find your desired
address.

TIMER MODE

These menu settings are for Timer mode. Make these setting
before activating the Timer Mode.
u.XXX -
This is the Volume setting (output intensity).
1. Press the either the MENU button until "u.XXX" is displayed.
2. Press the UP or DOWN buttons to change the output inten-
sity. 5 is the lowest output while 100 is highest output.
I.XXX -
This is the Interval setting (set time in between
fog output).
1. Press the either the MENU button until "I.XXX" is displayed.
2. Press the UP or DOWN buttons to change the output interval.
3 seconds is the lowest time while 255 seconds is longest time
between output.
d.XX -
This is the Dispersion time setting (length of fog
output).
1. Press the either the MENU button until "d.XX" is displayed.
2. Press the UP or DOWN buttons to change the dispersion
time. 1 second is the lowest time while 10 seconds is longest
output time.
ADJ Products, LLC - www.adj.com - Fog Fury 3000 Instruction Manual Page 8
System Menu Fog Fury 3000
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. On the "Master" unit press the MENU button until "M.XXX" is dis-
played. "XXX" representing either ON or OFF. Use the UP or
DOWN button to change the setting to ON. Make sure the "Slave"
units are all set to "Master" Off. The "Slave" unit will now follow the
"Master".
Fog Fury 3000
DMX Mode:
Operating through a DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs. This
function also allows you to use your fixtures as spot lights. The Fog
Fury 3000 has 3 DMX channels. See page 11 for the DMX traits.
1. This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MENU button until
"A.XXX" is displayed. "XXX" represents the current displayed ad-
dress. Use the UP or DOWN buttons to select your desired DMX
address.
3. Please see page 11 for DMX values and traits.
4. After you have set your DMX address plug in the fixture via the
XLR connections to any standard DMX controller.
ADJ Products, LLC - www.adj.com - Fog Fury 3000 Instruction Manual Page 9
Master-Slave Set Up
DMX Mode