Remote Operation - American DJ Fog Fury 3000 User Instructions

Fog Fury 3000
Always be sure to maintain an adequate supply of ADJ Brand
Fog Juice in the fluid reservoir. Running the fog machine dry will
cause pump failure and or clogging. This is the largest cause of
failure in fog and haze machines. Only ADJ Fog Juice is recom-
mended and not all fog juice is created equal.

Remote Operation:

Start by connecting the remote to the fog
machine. Once the machine is plugged in and turned on, a red power
LED on the remote will glow indicating the unit is receiving power.
The unit has a warm up time of about eight (8) minutes. After the unit
has warmed up, a GREEN LED on the remote will light indicating the
unit is ready to emit fog. To emit fog, simply press the button on the
remote for desired length of time. If the GREEN LED is on and fog
does not come out after holding the button down for 30 seconds,
check the fluid tank and make sure you have enough fog juice.
Caution:
Before removing or replacing the remote control unit
disconnect the power supply.
Fog Fury 3000
When storing your fog machine be sure to store it in a cool area.
Cover the machine so that dust does not build up on the unit. When
storing the machine for long periods of time, it is highly advised to at
least run the machine every 3-4 months. Long periods of inactivity
can severly shorten the life of your machine. Only run water based
fog juice through your machine. Never run plain water, vinegar, or any
other liquid solution through your machine. Running anything other
then water based fog juice will severly damage your machine.
ADJ Products, LLC - www.adj.com - Fog Fury 3000 Instruction Manual Page 10
Remote Operation
Proper Storage and Maintenance
Fog Fury 3000
Channel 1/ Volume Channel 2/ Interval
ADJ Products, LLC - www.adj.com - Fog Fury 3000 Instruction Manual Page 11
DMX Chart
Channel 3/ Duration