Timer Mode - American DJ Fog Fury 3000 WiFly User Instructions

Fog Fury 3000 WiFly
A.XXX -
DMX Address Setting. ("XXX" represents the dis-
played DMX address.)
1. Press the MENU, UP, or DOWN buttons until "A.XXX" is dis-
played. "XXX" represents the current address that is displayed
2. Press the UP or DOWN buttons to change/find your desired
address.

TIMER MODE

These menu settings are for Timer mode. Make these setting
before activating the Timer Mode.
u.XXX -
This is the Volume setting (output intensity).
1. Press the MENU button until "u.XXX" is displayed.
2. Press the UP or DOWN buttons to change the output inten-
sity. 5 is the lowest output while 100 is highest output.
I.XXX -
This is the Interval setting (set time in between
fog output).
1. Press the MENU button until "I.XXX" is displayed.
2. Press the UP or DOWN buttons to change the output interval.
3 seconds is the lowest time while 255 seconds is longest time
between output.
d.XX -
This is the Dispersion time setting (length of fog
output).
1. Press the MENU button until "d.XX" is displayed.
2. Press the UP or DOWN buttons to change the dispersion
time. 1 second is the lowest time while 10 seconds is longest
output time.
ADJ Products, LLC - www.adj.com - Fog Fury 3000 WiFly Instruction Manual Page 8
System Menu Fog Fury 3000 WiFly
M.XXX -
ter-slave set up.
1. Press the MENU button until "M.XXX" is displayed.
2. Press the UP or DOWN buttons to so that either "On" or "Off
is displayed. "On" will designate the unit as the "Master".
Fog Fury 3000 WiFly
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. On the "Master" unit press the MENU button until "M.XXX" is dis-
played. "XXX" representing either ON or OFF. Use the UP or
DOWN button to change the setting to ON. Make sure the "Slave"
units are all set to "Master" Off. The "Slave" unit will now follow the
"Master".
ADJ Products, LLC - www.adj.com - Fog Fury 3000 WiFly Instruction Manual Page 9
This is the menu activates the Master in a mas-
System Menu
Master-Slave Set Up