Threading The Bobbin Case - White 1066 Instruction Manual

4.-THREADING THE BOBBIN CASE
Fig 3
Before threading the bobbin case, study
Fig. 3, 4 and 5 to get a general idea
as to how it is done.
1. Hold the bobbin case with your left hand and put the bobbin into the
bobbin case with your right hand, leaving about two inches of the thread
end unwound (Fig. 3). As the bobbin is being inserted in the bobbin case,
the thread flow, you will note, is clockwise (Fig. 4)
2. While holding the bobbin case as before, grasp the thread end with your
right hand and guide
it
into the cross slot (Fig. 4).
Fig 4
3 Then pull it through under the tension spring of the bobbin case until it
enters the delivery eye (Fig. 5).
Fig 5
—5—